Fiberglass reinforcement 10 mm

Fiberglass reinforcement 10 mm

Today there is a process of manufacturing fiberglass reinforcement 10 mm in diameter in four rods. The pulling speed is 2 meters per minute, it is coiled only after full polymerization a few hours after the broaching. The temperature in the hottest furnace is not more than 180 g. Celsius. Cooling is exceptionally airy. The rod at the end is the standard

Стеклопластиковая-арматура-10

Стеклопластиковая-арматура-10-мм

I recall that a very important attribute of fiberglass reinforcement is the abrasive coating on the surface of the rod. Only sand-coated reinforcement provides the necessary coupling with concrete and allows the structure to work normally. More details about this can be found in the article “Carefully fiberglass reinforcement”

Fiberglass reinforcement 10